EasyManuals Logo

Ubiquiti EdgeRouter 4 User Manual

Ubiquiti EdgeRouter 4
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Front Panel Button
Reset
Button Description
Reset
There are two methods to reset the
EdgeRouter to factory defaults:
Runtime reset (recommended) The
EdgeRouter should be running after
bootup is complete. Press and hold the
Reset button for about 10seconds until
the LED for port eth3 starts flashing and
then becomes solidly lit. After a few
seconds, the LED will turn off, and the
EdgeRouter will automatically reboot.
Power-on reset Disconnect the Power
Cord from the Power Adapter. Press and
hold the Reset button while connecting
the power (refer to Connecting Power for
details). Keep holding the button until
the LED for port eth3 starts flashing and
then stops flashing after a few seconds.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ubiquiti EdgeRouter 4 and is the answer not in the manual?

Ubiquiti EdgeRouter 4 Specifications

General IconGeneral
RAM1 GB DDR3
Flash Storage4 GB eMMC
Max Power Consumption13W
Operating SystemEdgeOS
Operating Temperature-10 to 45° C (14 to 113° F)
Operating Humidity10 to 90% Noncondensing
CertificationsCE, FCC, IC
Ports3 x Gigabit RJ45, 1 x SFP
Power Input12VDC, 1A Power Adapter (Included)
Power MethodExternal AC/DC Adapter

Related product manuals