Ubiquiti EdgeRouter X ER-X User Manual

Compliance
FCC
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operations of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.

Ubiquiti EdgeRouter X ER-X Specifications

General

Model	EdgeRouter X ER-X
Category	Network Router
Ports	5 x Gigabit Ethernet
Processor	Dual-Core 880 MHz MIPS1004Kc
RAM	256 MB DDR3
Flash Storage	256 MB NAND
Max Power Consumption	5W
Operating System	EdgeOS
Operating Temperature	-10 to 45° C (14 to 113° F)
Operating Humidity	10 to 90% Noncondensing
Certifications	CE, FCC, IC
Switching Capacity	1 Gbps
Power Input	12V DC, 0.5A
Power Method	Passive PoE
Dimensions	110 x 75 x 22 mm (4.33 x 2.95 x 0.87 in)