Ubiquiti EdgeRouter X ER-X User Manual

Back Panel
PowerGround
Reset
Button Description
Reset
There are two methods to reset the
EdgeRouter X to factory defaults:
Runtime Reset (Recommended)
The EdgeRouter X should be running after
bootup is complete. Press and hold the Reset
button for about 10 seconds until the eth4
LED starts flashing and then becomes solidly
lit. After a few seconds, the LED will turn off,
and the EdgeRouter X will automatically
reboot.
Power‑on Reset
1. Disconnect the Power Adapter from the
EdgeRouter X.
2. Press and hold the Reset button while
connecting the Power Adapter to the
EdgeRouter X. Keep holding the button
until the eth4 LED starts flashing and then
stops flashing after a few seconds.
Detail Description
Ground
ESD grounding for enhanced ESD protection.
The ground wire and screw with washer
are not included (recommended screw size:
M3-0.5 x 4 mm).
Power Connect the Power Adapter.

Ubiquiti EdgeRouter X ER-X Specifications

General

Model	EdgeRouter X ER-X
Category	Network Router
Ports	5 x Gigabit Ethernet
Processor	Dual-Core 880 MHz MIPS1004Kc
RAM	256 MB DDR3
Flash Storage	256 MB NAND
Max Power Consumption	5W
Operating System	EdgeOS
Operating Temperature	-10 to 45° C (14 to 113° F)
Operating Humidity	10 to 90% Noncondensing
Certifications	CE, FCC, IC
Switching Capacity	1 Gbps
Power Input	12V DC, 0.5A
Power Method	Passive PoE
Dimensions	110 x 75 x 22 mm (4.33 x 2.95 x 0.87 in)