Need help?Do you have a question about the Ubiquiti ES-48-500W and is the answer not in the manual?
General| Model | ES-48-500W |
|---|---|
| Type | Managed Switch |
| Ports | 48 |
| SFP Ports | 2 |
| SFP+ Ports | 2 |
| PoE Support | Yes |
| PoE+ IEEE 802.3at | Yes |
| PoE Budget | 500W |
| PoE Max. Wattage per Port by PSE | 30W |
| Switching Capacity | 104 Gbps |
| Power Method | AC |
| Supported Voltage Range | 100 - 240VAC |
| Operating Temperature | 0 to 40 °C |
| Certifications | CE, FCC, IC |
| VLAN | Yes |
| Input Frequency | 50/60 Hz |
| Power Supply | Internal |
| Max. Power Consumption | 500W |
| Operating Humidity | 10% to 90% non-condensing |
| Fan Type | 2 x Fans |
| Management | Web, CLI, SNMP |
Describes the structure of CLI commands, including keywords, parameters, and options.
Explains different CLI modes like User EXEC, Privileged EXEC, Global Config, and their prompts.
Covers commands for configuring logical interfaces, including IP address, subnet mask, and gateway.
Details commands for adding, managing, and deleting system users, including password policies.
Explains commands for configuring Simple Network Management Protocol (SNMP) on the switch.
Describes commands for automatic firmware and configuration updates via TFTP.
Covers commands for configuring system logging, viewing logs, and managing logging settings.
Provides commands to view system features, components, configurations, and statistics.
Details commands for viewing and configuring port settings like speed, duplex, and shutdown.
Explains commands for configuring VLAN settings, including database, naming, and port acceptance.
Covers commands for configuring Spanning Tree Protocol (STP) to prevent network loops.
Describes commands for configuring and viewing ARP information on the switch.
Describes commands to enable and configure IP routing on the switch, including static routes.
Covers commands to configure and monitor the IP Helper agent for relaying UDP broadcast packets.
Details commands for managing IPv6 addresses, gateways, and autoconfiguration on network ports.
Describes commands for creating, deleting, and managing loopback interfaces.
Explains commands to configure and view Class of Service (CoS) settings for traffic prioritization.
Covers commands for configuring IP Access Control List (ACL) settings to filter traffic.
Describes commands to configure Auto-Voice over IP (VoIP) features for prioritizing voice traffic.
Lists available PoE commands for managing Power over Ethernet status and configuration on ports.
Lists common log messages related to core system components and their causes.
Lists common log messages related to management functions like SNMP, Telnet, SSH, and WEB.
Provides contact details for Ubiquiti Networks support engineers for resolving issues.
Lists online resources for support, community forums, and product downloads.
To Next Page