MAX-7 / NEO-7 - Hardware Integration Manual
UBX-13003704 - R09 Production Information Related documents
Page 51 of 52
Related documents
[1] NEO-7 Data Sheet, Docu. No GPS.G7-HW-11004
[2] MAX-7 Data Sheet, Docu. No GPS.G7-HW-12012
[3] u-blox 7 Receiver Description including Protocol Specification, Docu. No GPS.G7-SW-12001
[4] u-blox 7 Firmware Version 1.0 Release Note, Docu. No GPS.G7-SW-12003
[5] GPS Antenna Application Note, Docu. No GPS-X-08014
[6] UBX-G7020 Data Sheet, Docu. No GPS.G7-HW-10002
[7] GPS Compendium, Docu. No GPS-X-02007
[8] I
2
C-bus specification, Rev. 5, Oct 2012, http://www.nxp.com/documents/other/UM10204_v5.pdf
[9] GPS Implementation and Aiding Features in u-blox cellular modules, Docu. No GSM.G1-CS-09007
For regular updates to u-blox documentation and to receive product change notifications, please register
on our homepage (http://www.u-blox.com).
Revision history
MAX-7W added, Revision Chapter 3.4 Antenna supervision; MAX-7C: Higher backup
current, new Figure 42 and 43; DC-bloc removed from Figure 21 and Figure 22
NEO-7P added, Electrical Programmable Fuse (eFuse) added
Stencil thickness 150 um (Figure 9, 12, 13); Table 15: (MAX-7W: V_ANT ) added;
Added section 7.1.1 Population of Modules
ANT_ON description; Recommended GPS & GLONASS active antenna updated
Last revision with old document number GPS.G7-HW-11006
Antenna open circuit detection (OCD) for MAX-7W in section 3.4.3.3
Document status changed to Early Production Information.
LEA-7N removed; Figure 18, Figure 26 and Figure 30 updated.
Production Information; Appendix A.2 added: Design-in recommendations in combination
with cellular operation
Added information on RED DoC in European Union regulatory compliance (page 2), added
Intended use statement in section7.3.6 Electromagnetic interference (EMI), updated legal
statement in cover page and added Documentation feedback e-mail address in contacts
page.
To Next Page
Loading...
Need help?
General
