Ublox NINA-B3 Series - Antenna Accessories; Single Band Antennas

NINA-B3 series - System integration manual
UBX-17056748 - R13 Regulatory information and requirements Page 60 of 72
C1-Public
5.10.1 Antenna accessories
Name
U.FL to SMA adapter cable
Connector
U.FL and SMA jack (outer thread and pin receptacle)
Impedance
50 Ω
Minimum cable loss
0.5 dB, The cable loss must be above the minimum cable loss to
meet the regulatory requirements. Minimum cable length 100 mm.
Comment
The SMA connector can be mounted in a panel. For information
about integrating the U.FL connector, see also the Reference design
for external antennas (U.FL connector).
Approval
RED, MIC, NCC, KCC, ANATEL, ACMA and ICASA
Name
U.FL to Reverse Polarity SMA adapter cable
Connector
U.FL and Reverse Polarity SMA jack (outer thread and pin)
Impedance
50 Ω
Minimum cable loss
0.5 dB, The cable loss must be above the minimum cable loss to
meet the regulatory requirements. Minimum cable length 100 mm.
Comment
The Reverse Polarity SMA connector can be mounted in a panel. For
information about integrating the U.FL connector, see also the
Reference design for external antennas (U.FL connector). It is
necessary to follow this reference design to comply with the
NINA-W1 FCC/IC modular approvals.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, ACMA and ICASA
5.10.2 Single band antennas
NINA-B302 and NINA-B312 (u-blox LILY antenna)
Manufacturer
ProAnt
Gain
+3 dBi
Impedance
N/A
Size (HxWxL)
3.0 x 3.8 x 9.9 mm
Type
PIFA
Comment
SMD PIFA antenna on NINA-B302 and NINA-B312. Should not be mounted
inside a metal enclosure.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, ACMA and ICASA
NINA-B306 and NINA-B316
Manufacturer
ProAnt
Gain
+3 dBi
Impedance
N/A
Size (HxWxL)
1.1 x 3.4 x 10 mm
Type
PCB trace
Comment
PCB antenna on NINA-B306 and NINA-B316. Should not be mounted inside a
metal enclosure.
Approval
FCC, IC, RED, MIC, NCC, KCC, ANATEL, ACMA and ICASA