26 Cocoon 951 Twin
Cocoon 951 Twin
15.4 Outgoing Messages
Two outgoing messages of 2 minutes can be recorded (OGM1 and OGM2).
• Outgoing message 1 for the answering function and possibility for callers to leave a
message.
• Outgoing message 2 for the answering function without allowing callers to leave a
messages on the machine.
15.4.1 Recording outgoing messages (OGM 1 or OGM 2)
• Press the / -key to select the OGM.
• A voice will playback the recorded OGM
• Press the -key for two seconds
• Record the outgoing message after the beep
• Press the Stop -key to stop recording.
15.4.2 Playback the Outgoing Message
To check the outgoing message now set:
• Press the -key.
Note: To stop playing the welcome note briefly press the Stop -key .
15.4.3 Select outgoing message
• Press the / -key to switch between the 2 outgoing messages.
• The internal voice will confirm the set outgoing message.
15.4.4 Erasing the Outgoing Message
If you erase the outgoing message, the default message will be played ‘Please call later’ .
Erase the outgoing message as follows:
• Select the desired outgoing message by pressing the / -key.
• Press the key to play the outgoing message.
• Keep the key pressed down when the OGM is played back.
15.5 Turning Answering Machine On/Off
If the answering machine is on, the -LED will light up and the machine will
automatically pick up the line after a number of rings (see 'Setting Number of Rings').
• Press the key for 2 secs to switch on the answering machine. A voice confirms the
setting and says which outgoing message is active (OGM 1 or OGM 2).
• Press the key for another 2 secs to switch off the answering machine. A voice
confirms the setting.
The recording cannot exceed 2 minutes. If no outgoing message is
recorded, the prerecorded outgoing message is used.
To Next Page
Loading...
