Uconnect 5.0 NAV User Manual

AUX Mode
AUX Mode is entered by inserting a AUX device using a
cable with a 3.5 mm stereo audio jack into the AUX port
or by pushing the MEDIA mode button located below the
display. Once in MEDIA mode, press the “Source” button
and select AUX.
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert a Auxiliary device with the ignition
ON, the unit will switch to AUX mode and begin to play
when you insert the device cable.
Controlling The Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the VOLUME rotary knob, or with the volume of the
attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too low,
there will be insufficient audio signal for the radio unit to
play the music on the device.
32 MEDIA MODE

Uconnect 5.0 NAV Specifications

General

Brand	Uconnect
Model	5.0 NAV
Category	Car Receiver
Language	English