Troubleshooting
The
controller
indicator
light is off.
The drone
is under-
powered
or can not
fly.
The drone
could not
hover and
tilts to one
side.
1
3
4
Problem Problem Cause SolutionNo.
1. Low battery. 1. Replace the controller battery.
2. The batteries are incorrectly positioned.
2. Install the batteries following the polarity
indicators.
3. Poor Contact.
3. Clean between the battery and the battery
contacts.
1. Indicator light is off. 1. The same as above.
2. There is an interfering signal nearby. 2. Restart the drone and power on the controller.
3. Mis-operation.
3. Operate the drone step by step in accordance
with the user manual.
4. The electronic component is damaged for
fiercely crash.
4. To buy spare parts from local seller and replace
damaged parts.
1. The propeller is seriously deformed. 1. Replace the propeller.
2. Low battery. 2. Recharge the drone battery.
3. Incorrect installation of propeller.
3. Install the propeller in accordance with the user
manual.
2. The propeller is seriously deformed. 2. Replace the propeller.
3. The motor holder is deformed after violent
crash.
3. Replace the motor holder parts.
1. Improper Calibration.
1. Please refer to the Calibration Instruction.
4. The gyroscope did not reset after a serious
crash.
4. Put the drone on the flat ground for about 10s
or restart the drone to calibrate again.
Failed to
pair the
drone with
the
controller.
2
The drone
indicator
light is off.
Could not
see the
picture.
5
6
1. Low battery. 1. Recharge the drone battery.
5. Motor is damaged. 5. Replace the motor.
2. The battery is expired or over discharge
protection.
2. Buy a new battery from local seller to replace
the battery or charge the battery in accordance
with the use manual.
3. Poor contact. 3. Connect and disconnect the battery.
1. There is an interfering signal nearby.
1. Practice and read the cellphone controlling
instruction carefully.
2. Camera is damaged. 2. Replace Camera.
Hard to control by
cellphone.
7
Not experienced enough.
Practice and read the cellphone controlling
instruction carefully.
Can’t
position
hold.
9
1. Flying exceed the max recommended altitude. 1. Do not fly the drone higher than 8M
2. Flying in dim light. 2. Fly the drone in a space with good light.
The drone’s LED light
is still flashing rapidly
after pairing.
10
1. The Optical Flow Position board is
damaged.
1. Visit local distributor to buy the replacement part.
2. The Optical Flow Position board is
not in good connection with cable.
2. Reconnect the Optical Flow Position board.
The Optical Flow Sensor doesn’t
detect moving object.
It will work normally after the drone takes off.
The drone’s LED light
is flashing slowly
after pairing.
11
Can’t
altitude
hold.
8
1. The propeller deformed seriously. 1. Replace propeller.
2. The motor is damaged. 2. Replace the motor.
3. Atmospheric pressure is not stable. 3. Refer the altitude hold mode of use manual .
25
www.udirc.com
To Next Page
Loading...
