About the DXP4800 Plus
UGREEN DXP4800 Plus is a network-attached storage device designed for home and personal users.
The DXP4800 Plus works as an intelligent data management center where users can store and access
data via smartphones, laptops, tablets, and TVs anywhere there is network access.
Instructions Before Use
In order to ensure data transmission efficiency, it is recommended to use a router or switch with 10-Gigabit
LAN ports or higher and to connect the NAS using the included Ethernet cable (CAT7 or higher).
It is recommended to use new hard drives. When installing ANY drive(s), the NAS system will format the drive,
erasing ALL existing data. Ensure any important data is backed up prior to installation.
Please only use the original power adapter, or a safety-certified power adapter, that meets the power
specifications for this device.
Do not insert or remove hard drives when NAS device is on. If necessary, please turn off the device first by
using the app to prevent potential file loss, data corruption, or drive damage.
ONLY update firmware with a stable power supply. Do NOT disconnect the power supply during the update
process.
After unbinding the device, all data will be removed and can NOT be retrieved. Ensure data is backed up
appropriately before unbinding the device.
·
·
·
·
·
·
Package Contents
1 2
2×Hard Drive Tray Key1×User Manual 1×Warranty Card
1×Power Adapter
(DC 19V/7.9A)
2×Ethernet Cable
(CAT7)
2×SSD Silicone Pad
(For Thermal Conduction)
1×Network Attached Storage
(For 2.5-inch
Hard Drive Installation)
Screws &
Screwdriver
To Next Page
Loading...