-10-
Commence wiring work only after removing the power plug or turning it off. Do not
carry out wiring work while the wiring is live under any circumstances. Working under
such conditions may result in electric shock.
Ensure that all wiring work is performed in accordance with electrical equipment
standards and internal wiring regulations. Incorrect wiring work may result in fire.
When the pump is directly connected to the user’s device (plug is not the main
disconnection), connect a suitable circuit breaker to the pump at the end user’s side.
Passing current through the earth wire in the event of a short reduces the danger of
electric shock.
Use a power cord with the appropriate plug and earth wire with the pump.
Besides the power cord, There is a place that can connect the ground wire to the
pump. Ground wire attachment point the (M4 tap) has been provided on the base
side of the pump. (Refer to fig. 1.) Therefore, in case of installing the pump in the
housing, etc., it can also be connected to housing and the pump in the ground wire.
Ensure that wiring and earthing work is done in accordance with local regulations
and safety requirements.
Unsuitable earthing brings the danger of electric shock.
When repairing or changing the plug or electric cord, ensure that it is not connected
to anything other than the earth.
Irrespective of the presence or absence of yellow stripes, the green insulated
covering indicates the earth wire.
If the appropriate wiring method is unclear, or if there are any questions, check with
an electrical technician or the service division.
Do not change the supplied plug. If it is unsuitable for the power supply, have the
wiring work done by an electrical technician.
The pump must be earthed to the wiring or through a metal surface connected to
earthed equipment.
WARNING
Warning
Warning
Caution
Caution
Caution
Caution
To Next Page
Loading...
