UNI-T UPO3000E Series - Page 69

UNI-T UPO3000E Series

69 pages

To Previous Page

To Previous Page

Loading...

67

Table of Contents

Default Chapter3
- General Safety Overview3
- Safety Terms and Symbols3
- UPO3000E Series Ultra Phosphor Oscilloscope Introduction4
- Table of Contents5
Chapter 1 Getting Started Guide7
- General Inspection7
- Before Use7
- Front Panel8
- Rear Panel9
- Operation Panel9
- User Interface12
- Special Symbols Introduction13
Chapter 2 Vertical Channel Settings14
- Open/ Active/ Cloase Analog Channel14
- Channel Coupling14
- Bandwidth Limitation14
- Volts/DIV14
- Probe14
- Invert15
- Bias15
- Unit15
Chapter 3 Horizontal System Settings15
- Horizontal Scale15
- ROLL Mode16
- Extended Window16
- Independent Time Base16
- Trigger Hold-Off17
Chapter 4 Sampling System Settings18
- Sampling Rate18
- Acquisition Mode19
- Memory Depth20
Chapter 5 Trigger System Settings20
- Trigger System Interpretation20
- Edge Trigger21
- Pulse Width Trigger22
- Video Trigger22
- Slope Trigger23
- Runt Trigger24
- Window Trigger25
- Delay Trigger26
- Timeout Trigger27
- Duration Trigger28
- Setup/Hold Trigger29
- Nth Edge Trigger30
- Code Pattern Trigger31
Chapter 6 Protocol Decoding32
- RS232 Decode (Optional)32
- I2C Decode (Optional)34
- USB Decode (Optional)35
- CAN Decode (Optional)36
- SPI Decode (Optional)38
Chapter 7 Mathematical Operation40
- Mathematical Function40
- Fft40
- Logic Operation41
- Digital Filter42
- Advanced Operation43
Chapter 8 Display System Settings44
- Waveform Display Setting44
- XY Mode44
- Application of XY Mode45
Chapter 9 Automatic Measurement46
- Parameter Measurement46
- Automatic Measurement Menu47
- All Parameters Measurement48
- User Defined Parameters48
Chapter 10 Cursor Measurement49
- Time Measurement49
- Voltage Measurement49
Chapter 11 Storage and Load50
- Setting Storage and Load50
- Waveform Storage and Load50
- Print Screen51
Chapter 12 Auxiliary Function Settings52
- System Function Settings52
- Waveform Recording53
- Pass/Fail54
- System Upgrade55
Chapter 13 Additional Function Keys56
- Auto Setting56
- Run / Stop56
- Clear56
- Factory Setting56
Chapter 14 System Prompts and Troubleshooting58
- System Prompt Information Description58
- Trouble Shooting58
Chapter 15Technical Index59
Chapter 16Accessories68
Appendix A Accessories and Options68
Appendix B Maintenance and Cleaning68
Appendix C Warranty Overview68
Appendix D Contact Us68

Other manuals for UNI-T UPO3000E Series

Programming Manual94 pages

Related product manuals

UNI-T UPO1000X Series

Preview: UNI-T UPO2000E Series

UNI-T UPO2000E Series

Preview: UNI-T UPO2000CS Series

UNI-T UPO2000CS Series

UNI-T UPO1000CS Series

Preview: UNI-T UT521

Preview: UNI-T UT502A

Preview: UNI-T UT501A

Preview: UNI-T UT501B

Preview: UNI-T UTD2025C