To Next PageTo Next Page
Need help?Do you have a question about the UNI-T UT2000 series and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Display | LCD |
| Type | Clamp Meter |
| Model | UT2000 series |
| Frequency (Hz) | 10Hz - 1MHz |
| Current Measurement Range | 0.1A - 100A |
| Voltage Measurement Range | 0.1V - 600V |
| Resistance Measurement Range | 0.1Ω - 20MΩ |
| Frequency Measurement Range | 10Hz - 1MHz |
| Safety Rating | CAT III 600V |
Describes the graphical user interface elements and controls of the oscilloscope software.
Details the functions available within the software's menu system, including document and mathematics operations.
Explains the status bar and specific channel settings (CH1, CH2) and their parameters.
Step-by-step instructions for controlling the oscilloscope using a USB connection and the software interface.
Step-by-step instructions for controlling the oscilloscope via a serial (RS-232) connection and the software.
Lists the necessary hardware ports (USB, RS-232) for connecting the oscilloscope to a computer.
Detailed procedure for installing the necessary device drivers for the oscilloscope on the host computer.
Step-by-step guide to installing the UT2000_3000 Series Computer Testing & Control Software.
Explains common prompts encountered during software operation and their meanings.
Provides solutions for common problems, focusing on serial and USB configuration issues.
