Make sure the Sleep Mode is not on if you found
there is no display on the LCD after turning on the
Meter.
Make sure the Low Battery Display is not on,
otherwise false readings may be provided.
Pay extra attention to the
symbol which is located
besides the input terminals of the Meter before
carrying out measeurement.
l
l
l
(figure 3)
The DC Voltage ranges are: 200mV, 2V, 20V, 200V and
1000V. To measure DC voltage, connect the Meter as
follows:
13
Model UT50D: OPERATING MANUAL
To Next Page
Loading...
