1. According to the size of the tested object’s leads,
insert multi-purpose socket or test clip into the mA
and V terminal.
2. Set the rotary switch to an appropriate measurement
position in HLx range.
3. Insert the tested object into the corresponding jack
of the multi-purpose socket or connect the test clip
to the object being measured.
The measured value shows on the display.
Measurement Operation(9)
l If the value of inductance to be measured is unknown,
use the maximum measurement position, and reduce
the range step by step until a satisfactory reading is
obtained.
l When inductance testing has been completed, remove
the multi-purpose socket or test clip from the input
terminal, and remove multi-purpose socket or test clip
away from the input terminal of the Meter.
( figure 7)
21
Model UT50D: OPERATING MANUAL
To Next Page
Loading...
