9
A.5 Installation and assembly
• The installation must be carried out by a specialised personnel.
• Follow the installation instruction supplied with the appliance.
• Do not install a damaged appliance. Any missing or faulty parts must be replaced with
original parts.
• Do not make any modifications to the parts supplied with the appliance.
• Disconnect the appliance from the power supply before carrying out any installation
procedure. Connect the appliance to the power supply only at the end of the installation.
• The appliance is not suitable for installation outdoors and/or in places exposed to
atmospheric agents (rain, direct sunlight, freeze, humid and dusty location, etc.).
• Make sure that the floor where you install the appliance is flat, stable, heat resistant and
clean.
• Access to the service area is limited to persons with the necessary knowledge of safety
and hygiene as well as practical experience of the device.
• Leave enough free space around the appliance to facilitate its use and to preform any
maintenance operations.
A.6 Water connection
• The plumbing connections must be carried out by a specialised personnel.
• The machine is to be connected to the water mains using the new supplied hose-sets.
Do not use old hose sets.
• Always use a new set of joints if you remove and re-install the water inlet pipe to the
machine.
• Before connection to new pipes, pipes not used for a long time, where repair work has
been carried out or new devices fitted (water meters, etc.), let the water flow until it is
clean and clear.
• The operating water pressure (minimum and maximum) must be between:
– 1 bar [0.1 MPa] and 8 bar [0.8 MPa];
• Make sure that there are no visible water leaks during and after the first use of the
machine.
• Install an approved dual check valve upstream according to the regulation of the
installation country.
A.7 Electrical connection
• Work on the electrical systems must only be carried out by a specialised personnel.
• Make sure that the electrical information on the rating plate agrees with the power supply.
• Make sure to install the appliance in accordance with the safety regulations and local
laws of the country where used.
• If the power cable is damaged it must be replaced by the Customer Care Service or in
any case by specialised personnel, in order to prevent any risk.
• The appliance must be correctly earthed. The manufacturer is not responsible for the
consequences of an inadequate earthing system.
• To protect the power supply of the appliance against short circuits and/or overloads,
install a thermal fuse or a suitable automatic thermal magnetic circuit breaker, ADS
(Automatic Disconnection of Supply).
• To protect the power supply of the appliance against current leakages, install a high-
sensitivity manual reset RCD (Residual Current Device), suitable for overvoltage
category III.
For protection against indirect contacts, refer to point 6.3.3 of EN 60204-1 (IEC 60204-1)
with the use of protection devices that ensure automatic cut-off of the supply in case of
To Next Page
Loading...
Need help?
General
