V2403
The sedimenter separates water from fuel.
When the sedimenter warning light comes on, it
indicates that more than the specied amount of water
has accumulated in the sedimenter. Remove the water
in the following matter:
1. Shut off the engine.
2. Turn the sedimenter cock 90° upward to close it.
3. Remove the retaining ring and drain the lter cup.
4. Reinstall the sedimenter. Reset the cock into the
original position.
5. Loosen the fuel lter drain plug.
6. Pump the priming pump on top of the fuel lter a few
times to drain water from inside the lter.
7. After draining water, reinstall the drain plug and
tighten securely.
CAUTION
Wipe away any spilt fuel from areas around the
sedimenter. There is a danger of causing a fire
hazard.
8. Start the engine and make sure the sedimenter
warning light is off.
SEDIMENTER
RETAINING RING
FILTER CUP
COCK
FUEL FILTER
PRIMING PUMP
DRAIN PLUG
4-22
To Next Page
Loading...
