6
Data output For RS232 printer and firmware
upgrade
For RS232 printer and firmware
upgrade
Power Requirements 90-240Vac, 50-60 Hz 90-240Vac, 50-60 Hz
Dimensions 550W x 400D x 270H (mm) 550W x 400D x 270H (mm)
Light Source Tungsten Halogen Tungsten Halogen/Deuterium
Weight 46 lbs. /21kg 46 lbs. /21kg
Installation:
1. After carefully unpacking the contents, check the materials with the packing list to ensure that
you have received everything in good condition.
2. Place the instrument in a suitable location away from direct sunlight. In order to have the
best performance from your instrument, keep it as far as possible from any strong magnetic or
electrical fields or any electrical device that may generate high-frequency fields. Set the unit up
in an area that is free of dust, corrosive gases and strong vibrations.
3. Remove any obstructions or materials that could hinder the flow of air under and around the
instrument.
4. Turn on the instrument and allow it to warm up for 15 minutes before taking any readings.
To Next Page
Loading...
Need help?
General
