D2
W
Wait until EasyRTOS booted:
Check memory . . . . . . . .√
WL : 656.1nm 16:20:18
Init Printer . . . . . . . . . . .√
Init Comm Port . . . . . . . .√
Start Kernel . . . . . . . . . .√
Positioning . . . . . . . . . . √
System calibrating? No
Warm up 15 minutes. . . .√
Fig 5
D2
W
Wait until EasyRTOS booted:
Check memory . . . . . . . .√
United Products & Instruments Inc.
WL : 656.1nm 16:28:03
Init Printer . . . . . . . . . . .√
Init Comm Port . . . . . . . .√
Start Kernel . . . . . . . . . .√
Positioning . . . . . . . . . . √
Init AD Converter . . . . . .√
Search 656.1nm . . . . . .√
Check Energy . . . . . . √
Fig 6
WL : 656.1nm 16:31: 35
D2
W
Cell #1
1
2
3
8
7
4
5
6
Basic mode
Quantitative
WL scan
Kinetics
DNA/Protein
Multi WL
Utility
Defined test
United Products & Instruments Inc.
UNICO SPECTROPHOTOMETER
SPECTRO-QUEST
Fig 7
Ÿ Basic operation
Blank
² Push the blank cuvette into the lightpath.
² Press the key 【0Abs/100%T】for blanking
Note:1. If the reference solution is too thick, “Energy Low…”will appear
following the “Blanking…”on the screen (Fig 8).If “Energy too Low…” appears
following the “Blanking…”,the test will be paused and “Warning…”will appear
on the screen.(Fig 9).
2.If no automatic changer installed “cell #1” and “Max E” will disappear in
Fig8