Need help?Do you have a question about the UNICORECOMM UM982-EB and is the answer not in the manual?
This document is written for technicians familiar with GNSS modules.
Details the 3.3V output voltage provided by the LDO circuit for powering the UM982-EB.
Describes the 5V output voltage from the DC/DC boost circuit used to feed the antenna.
Explains the requirement for backup power for the UM982 module's hot start function and its input voltage range.
Details the antenna short protection circuit, its load management chip, and triggering conditions for protection.
Describes the antenna feed circuit components like anti-reverse current, anti-surge design, filters, and ESD protection.
This document is written for technicians familiar with GNSS modules.
Details the 3.3V output voltage provided by the LDO circuit for powering the UM982-EB.
Describes the 5V output voltage from the DC/DC boost circuit used to feed the antenna.
Explains the requirement for backup power for the UM982 module's hot start function and its input voltage range.
Details the antenna short protection circuit, its load management chip, and triggering conditions for protection.
Describes the antenna feed circuit components like anti-reverse current, anti-surge design, filters, and ESD protection.
General| Horizontal Accuracy | 1.5m |
|---|---|
| Data Format | RTCM 3.2 |
| Interfaces | UART, USB, CAN |
| Operating Temperature | -40°C ~ +85°C |
| USB Ports | 1 x USB |
| Network | 1 x Ethernet, 1 x CAN |
To Next Page