Uniden BCD396XT Reference Manual

Friday, November 07, 2008
162
If the scanner finds a Close Call transmission, it displays "CC Found!" on the first line. Then it performs
duplication check in the "Close Call" System and displays "Memory Check" on the first line. While storing
the frequency to Memory, it displays "Storing" on the first line.
The scanner will stop storing if the number of found frequencies reaches Max Auto Store. Then it displays
"Limit Reached" and sounds a Confirmation Tone.
When it exceeds a limit for creating a System/Group/Channel while storing, the scanner stops storing.
Then it displays "Over Limit" and sounds an Error Tone.
If the scannerƐŵĞŵŽƌLJ becomes full during the storing operation, it displays "Memory Full" on the first
line and sounds an Error Tone.
The scanner does not automatically exit from CC Auto Store Mode.
Pressing [Hold / ] stops this operation and goes to Close Call Only Mode. (It does not go to Close Call
Hold.)
Pressing [Scan / srch] exits this mode and goes to Scan Mode.
Pressing [Menu] exits this mode and goes to Menu Mode. If you exit from Menu Mode, it goes to Close
Call Only Mode.
Pressing [Menu] in Function Mode exits this mode and goes to the Close Call Menu.
Pressing [Scan / srch] in Function Mode prompts "Quick Search?" and exits this mode. Then press [E / yes /
gps] to go to Quick Search Mode, press [. / no / pri] to go to Search Menu, press [L/O] to cancel the prompt
and go to Close Call Only Mode, or press [Hold / ] to go to Quick Search Hold Mode.
CC Hit with Scan
The scanner stores the detected frequency in the Close Call Hits system. When the scanner is turned off,
the stored frequencies are lost.
This system can store up to 10 frequencies. When there are already 10 frequencies in the Close Call Hits
system, storing a new frequency overwrites the oldest one.
If this system does not have frequencies, the scanner does not scan this system.
The scanner does not store frequencies you skipped by pressing [L/O].
You set the Quick key, lockout state, number tag and hold time for this system at Hits with Scan
.
Direct Entry / Quick Save / Go to Quick Search Hold Mode
Whenever it is in Close Call Hold Mode, you can enter a frequency or a TGID by pressing [0-9 ] or [. / no /
pri] key, then press [E / yes / gps] to quickly store the entry.
(See Direct Entry
for details.)

Uniden BCD396XT Specifications

General

Belt clip	Yes

Weight and Dimensions

Weight	907 g
Dimensions (WxDxH)	51 x 25 x 1152 mm