UniFi UBB User Manual

Note: This device meets Max. TX power limit per ETSI
regulations.
Note: Fixed service or any restrictions for authorization of use
shall follow local country regulations.
The following apply to products that operate in the 5 GHz frequency
range:
Note: This device is restricted to indoor use only when
operating in the 5150 - 5350 MHz frequency range within all
member states.
Note: All countries listed may operate at 30 dBm. BFWA
member states may operate at 36 dBm.
Note: Operation in the 5.8 GHz frequency band is prohibited in
BFWA member states. Other countries listed may use the 5.8
GHz frequency band.
WEEE Compliance Statement
Compliance
FCC
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions.
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for

UniFi UBB Specifications

General

Device Type	Wireless Bridge
Frequency Band	5 GHz
Operating Temperature	-40 to 60° C (-40 to 140° F)
Weatherproof	Yes
Certifications	CE, FCC, IC
Management	UniFi Network Controller
Product Name	UniFi Building-to-Building Bridge
Category	Wireless Access Point
Range	Up to 500 meters
Networking Interface	1 Gbps Ethernet
Power Method	Passive PoE (Pairs 4, 5+; 7, 8 Return)
Enclosure Materials	Polycarbonate
Power Supply	PoE injector (included)
Operating Humidity	5 to 95% Noncondensing
Wireless Security	WPA2-PSK
Wireless Technology	802.11ac
Mounting	Pole, Wall