e. Protective bonding must be installed in accordance with local
national wiring rules and regulations.
Limited Warranty
ui.com/support/warranty
The limited warranty requires the use of arbitration to resolve disputes
on an individual basis, and, where applicable, specify arbitration instead
of jury trials or class actions.
Limited Warranty
ui.com/support/warranty
The limited warranty requires the use of arbitration to resolve disputes
on an individual basis, and, where applicable, specify arbitration instead
of jury trials or class actions.
Compliance
FCC
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions.
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operations of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
To Next Page
Loading...
Need help?
General
