UNIQUE ELITE 30E&36E
32
3. Blot the area dry with a clean, soft towel and allow to fully dry before using the
oven.
Stainless Steel Surfaces
Clean stainless steel surfaces with a solution of mild detergent and hot water.
Wipe away any remaining residue with a clean, damp cloth. Do not use any
cleaning product containing chlorine bleach. Do not use harsh or abrasive
cleaning agents or steel wool pads as these will damage the surface
Replacing the burner parts:
When replacing the burners, make sure that the two locating pins on the bottom of
the brass flame spreader are properly aligned with the locating pin holes on the top
of the simmer ring.
Incorrect alignment will produce a potentially dangerous flame and poor burner
performance.
Replacing the oven light bulbs
To replace either of the oven light bulbs, release the glass cover on the lamp holder,
and then replace the old bulb with a new bulb.
To Next Page
Loading...
