Unique UGP-36E OF1 - Troubleshooting; Burner Ignition and Flame Issues

UNIQUE ELITE 30E&36E
36
Troubleshooting Guide - UGP Elite 30E & 36E Off Grid
Symptom Possible Cause Solution
BURNERSWILL
NOTLIGHT.
Burnerpartsor
ignitersmaybe
wet,dirtyor
misaligned.
Checkthattheburnerpartsare
clean,dryandcorrectly
assembled.Checkthatthe
ignitersarecleananddry.
FLAMESDO
NOTBURNALL
AROUNDTHE
BURNERCAP.
Burnerpartsmay
bedirtyor
misaligned.
See“CareandCleaning”
instructions.
BURNER
FLAMESARE
VERYLARGE
ANDYELLOW.
Burnerbezel
portsareclogged.
Burnerportsor
burnercapsare
notpositioned
properly.
Cooktopisbeing
operatedwiththe
wrongtypeof
gas.
Regulatorisnot
installed,isfaulty,
orissetforthe
wrongtypeof
gas.
Cleanburnerbezelringports
with
straightenedpaperclip,needle,
orwire.
Removeandcarefullyre‐install
burnerbezelandcaps.
Ensurethatthetypeofcooktop
matchesthegassupply.
Checkinstallation,replace
regulator,orsetregulatorfor
propergas.
IGNITERSARE
SPARKINGBUT
BURNERSARE
NOTIGNITING.
Gasshut‐offvalve
isinthe“OFF”
position.
Turnshut‐offvalvetothe“ON”
position.

