UNIS DYNAMIC ORBS - Page 22

Dynamic Orbs GMP Manual
09/26/2023
21
Machine Test
：
Long press "Settings" button to enter. Press "Settings" button to select,
Press "Test" +, Press "Reset" -.
Settings
button
Press "Test" +, Press "Reset" -.
P0
Display Test
0-9 Loops
Press
Settings↓
P1
Input Test
The corresponding input value is displayed
according to IO
Press
Settings↓
P2
Bonus Plate Test
Displays the corresponding Bonus output value
Press
Settings↓
P3
IO Output Test
Displays the corresponding output value
according to IO
Press
Settings↓
P4
Drive Board Motor
Test
01
：
Small ball up motor
02
：
Big ball up motor
03
、
04
、
05
：
None
06
：
Turntable motor
07
：
Big ball motor
Press
Settings↓
P5
Fill Balls to push
plate(Auto)
Set to 10 to start filling, the display shows the
number of filled balls remaining.
Press
Settings↓
P6
Music Test
Display displays value is the corresponding
number of music
Press
Settings↓
P7
Refill big ball to
spiral tube
Press settings once, 1 big ball out
Press
Settings↓
P8
Refill big ball to
push plate
Press settings once, 1 big ball out
Press
Settings↓
P9
Ticket Test
Ticket out
Press
Settings↓
PA
Clear spiral tube
big ball
Set 10 to clear
Press
Settings↓
99
Quick Ticket
Dispensing
When there are a lot of tickets lacking, you can
set up a quick ticket from here.
1. If the number of ticket lacking is 2000, set
2000, and the number of ticket lacking after
exit is 0.
1. If the number of ticket lacking is 2580, set
2000, and the number of ticket lacking after
exit is 580.
Press
Settings↓
FF
Back To Game
Wait 3 seconds to exit. Press to return A0.
Press
Settings↓