UNIS DYNAMIC ORBS - Page 23

Dynamic Orbs GMP Manual
09/26/2023
22
Error Code
：
Er01:
Samll ball up motor/Sensor is faulty
Er06:
Turntable motor/Turntable sending sensor is faulty
Er07:
Turntable sensor is faulty
Er08:
Bonus plate reset failed
Er09:
Bonus plate turning sensor is faulty
Er10:
Bonus plate prizing sensor is faulty
Er11:
U3 board& Motor drive board communication is faulty
Er12:
U3 board&Reader communication is faulty
Er13:
Identify balls repeatedly
Er14:
Big ball up motor/Sensor is faulty
Er15:
Big ball sending motor/Sensor is faulty
ErFF:
Tilt alarm