Unison Research Unico Due User Manual

Unison Research

Unico Due
14
1. UNPACKING
Please make sure that the packaging is undamaged and the product has not suffered
from rough handling during transportation, otherwise we highly recommend to
contact your Authorised Dealer for advice before proceeding to install the unit.
Carefully remove your amplifier and all the accessories from the carton.
Inside the package you will find:
- 1 Unico Due amplifier
- 1 power supply cable
- 1 user manual
- 1 remote control handset
IMPORTANT! After unpacking, please allow some hours before operating
the device in order to let it adapt to the room temperature. This time is
needed to prevent any possible damage due to the condensation which can
eventually form during transportation. Please note that condensation can
form every time the amplifier is moved from a cold to a warm place.
Keep all packing materials: every time you will need to transport your Unico Due, its
original purpose-designed carton will provide the safest packing.
2. INSTALLATION
The Unico Due should be positioned in a safe place on a flat surface, out of reach of
children.
Adequate clearance (at least 5cm) must be left above and around the device to
guarantee good ventilation.
We also suggest to leave enough free space behind your Unico Due to allow the
connecting cables sufficient room to bend without forcing or straining them, and we
strongly recommend not to place the device directly on the top of a power amplifier
or, in general, close to a source of heat.
3. CONNECTION TO MAINS
The Unico Due is set at the factory to the appropriate mains voltage of the country it
is shipped to. Before switching on the amplifier, please check that the mains voltage
indicated on the rear panel corresponds to the mains voltage in your area.
IMPORTANT! The voltage setting may not be changed by the user.
Never connect the Unico Due to AC mains if the local voltage doesn’t match the
value indicated on the rear panel!
The mains fuse is located in the fuse-holder integrated in the IEC mains socket.
IMPORTANT! Always replace fuses with new ones of the same type and value.

Unison Research Unico Due Specifications

General

Signal-to-Noise Ratio	>90 dB
Type	Integrated Amplifier
Output Power	100W per channel (8Ω)
Inputs	4x Line
Outputs	Speaker Terminals
Tube Complement	2x ECC83 (12AX7)
Total Harmonic Distortion	<0.1%