After click “Config by IE”, it should pop-up the web page below:
Software Installing
HT630 wireless-Serial Server is shipped with default settings shown in the following table:
Property Default Value
Default SSID wlandemo
IP Address 192.168.1.250
Gateway 192.168.1.254
Subnet Mask 255.255.255.0
User Name admin
Password password
RS232 Setup 38400,None, 8, 1, No flow control, Type: TCP client, Destination IP: 192.168.1.2,
destination port 4660, Virtual COM enable
Configure by web server
Step 1: Make sure ones PC is located on the same subnet as HT630.
Step 2: Open a web browser, then enter in the IP address of HT630 to be configured.
Note: Default user name is admin and default password is password.
Step 3: HT630's network, Basic Setup, Radio, Security and RS232 Setup settings should be configured in
different web pages.
Step 4: Click “Apply” button to save settings and make the change effective .
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
24
To Next Page
Loading...
