Wireless Connectivity
The MS350 can be linked to any Bluetooth (BT) enabled
device which can accept such a connection with other
devices. To implement this feature, user should set the
imager to “Cradle/Dongle connection auto detection” first.
And then set the PIN code to 0000 assigned to the target
Bluetooth device. In this case, the PIN code of the Bluetooth
enabled device should be set to 0000 to be identical with
your imager.
? Cradle connection only – The imager can be used
only with cradle (Default).
? Cradle/Dongle connection auto detection – The
imager can be linked to either a cradle or other
Bluetooth enabled devices.
? Set PIN code to 0000
Note: The imager only support “Serial Port Profile ” under
“Dongle connection”
*$%-$0000%%*
*$%-1AB00%%*
*$%-1AB01%%*
To Next Page
Loading...
Need help?
General
