xiv
© 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
3.8 ABC-Codabar CX-Codabar ..................................................................30
3.9 Codabar coupling, Adjacent Required..................................................31
3.10 Standard & Full ASCII 39, Code 32 ....................................................33
3.11 UPC-E ................................................................................................34
3.12 UPC-E System Number......................................................................35
3.13 UPC-A................................................................................................36
3.14 EAN-8.................................................................................................37
3.15 EAN-13, ISBN, ISSN, ISMN ...............................................................38
3.16 EAN/UCC-128, Code 128...................................................................40
3.17 GS1 DataBar, Limited, Expanded.......................................................41
Chapter 4 – Command Settings...........................................................44
4.1 General setting.....................................................................................44
4.2 Beep Tone, Terminator .........................................................................47
4.3 Send Data Length, Preamble & Postambnle........................................49
4.4 Accuracy Adjustment............................................................................51
4.5 Code ID, Inverse Barcode ....................................................................52
4.6 Symbologies Code Identifier.................................................................54
4.7 Set Code ID..........................................................................................56
4.8 Inter-block and Inter-character Delay ...................................................58
4.9 Keyboard Layout ..................................................................................59
4.10 Caplock Mode,Numeric Key, HT/CR/ESC Conversion.......................60
Appendix A – Full ASCII table & Function Key table.................62
A-1 MIN/ MAX Length setting Procedure ...................................................62
A-2 FULL ASCII Table (CODE 39)..............................................................64
A-3 Function Key Table (Code39) ..............................................................73
Appendix B – Default Table ..................................................................77
B-1 Default Table 1.....................................................................................77
B-2 Default Table 2.....................................................................................78
B-3 Default Table 3.....................................................................................79
To Next Page
Loading...
