-32- © 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
Adjacent Required
On
Off
If CODABAR ADJACENT is enabled, the scanner
will only read two adjacent Codabar bar codes; a
single bar code will not be read.
Notes:
1. Both ABC-Codabar and CX-Codabar
can be enabled together, except
when Codabar-Coupling is also
enabled.
2. If ABC-Codabar, CX-Codabar, and
Codabar-Coupling are all enabled at
the same time, the scanner will read
only Codabar- Coupling, that is,
ABC-Codabar, CX-Codabar will be
considered coupling formats.
Setting Procedure – Set Insert Data
Step 1- Scan SET INSERT DATA.
Step 2- Scan any combination of alphanumeric
characters from FULL ASCII Table.
Step 3- Scan SET INSERT DATA.
Reset
Notes :
1. The scanner will beep three times as a
reminder that a setting is not yet complete.
2. If you make a mistake, forget a step, etc.,
Scan RESET to start again.
To Next Page
Loading...
Need help?
General
