Unitech MS912

- 23 - - 24 -
MEMORY MODEBATCH MODE
Once enabled, the scanner will stop sending data via Bluetooth
and start storing data into the internal flash disk (2MB)
For memory version only
. R001$
*.R001$*
ENABLE MEMORY
. R002$
*.R002$*
DISABLE MEMORY
. R005$
*.R005$*
DELETE LAST RECORD
. R004$
*.R004$*
CLEAR ALL RECORD
Delete Last Record/ Clear All Record
MEMORY MODE
The following pages only apply to the memory
version mini wireless scanner, MS912M (P/N:
MS912-5UBB00-SG), which can be easily
distinguished by an “M” mark on the rear of
the scanner.
Being out of range, the scanner will temporarily
keep scanned data in its memory buffer(2K RAM)
until the buffer is full. The scanner will send all
stored data back to the host after getting in range.
*Note: Batch Mode will not function when Memory
Mode is enabled, or no connection is made beforehand.