Unitech MSR120 - L (4 Ch) Green LED on; L (6 Ch) Green LED off; M (4 Dh) Red LED on; M (6 Dh) Red LED off

MSR120 Programmer’s Manual UDN PM010, Rev. 1.1
Section 4 – Commands and Responses 2003/1/21
L (4Ch) " Green LED On
l (6Ch) " Green LED Off
M (4Dh) " Red LED On
m (6Dh) " Red LED Off
Comments
1 Turn green/red LED on/off, as specified.
2 Transmit "ACK".
( (28h) " Green LED Flash
) (29h) " Red LED Flash
Comments
1 Begin flashing the specified LED on and off (approximately 250mSec On and 250mSec Off). Continues
flashing until changed by another LED command or by continued interrupt mode operation.
2 Transmit "ACK".
Z (5Ah) " One Long Beep
z (7Ah) " One Short Beep
Comments
1 The buzzer beeps a long (approx. 0.5mSec)/short (approx. 0.2mSec) beep.
2 Transmit "ACK".
DC3 (13h) " Pause Transmit
Comments
Stop transmitting data.
DC1 (11h) " Resume Transmit
Comments
Resume transmission of data.
T (54h) " Card Type Report
Comments
Transmit a byte, which represent the swiping card type.
1 (31H) CA old DMV
2 (32H) AAMVA
3 (33H) ISO
4 (34H) JIS
6 (36H) Trade Show Card
0 (30H) No data (sending T command just right after power on)
Page 4-3
Proprietary and Confidential Total 36 pages