MSR120 Programmer’s Manual UDN PM010, Rev. 1.1
Section 5 – Configuration Commands 2003/1/21
RE2 (52h 45h 32h) ! Read Prefix & Suffix Setting Status of Tracks
Command Form: <09h 00h 03h 52h 45h 32h 2Fh >
This is used to send byte 7-42 data of EEPROM to host.
RE3 (52h 45h 33h) ! Read Channel Setting Status of Tracks
Command Form: <09h 00h 03h 52h 45h 33h 2Eh>
This is used to send byte 743-77 data of EEPROM to host.
Note: In the case of RE1, RE2, RE3 command, the device transforms the EEPROM data from hexadecimal code
into ASCII code, and send it out. For example, if the EEPROM data is “2Ah” the host will receive “32h 41h”.
Hence, executing these 3 commands, the host will serially transform each 2 bits of received date into hexadecimal
code.
Page 5-9
Proprietary and Confidential Total 36 pages
To Next Page
Loading...