3736
Selecting from multiple inputs using the uDirect 2
With only one audio source (e.g., from a Bluetooth
transmitter), each press of the access (
) button
will pause or resume the audio source.
Multiple sound sources
can be accessed
sequentially by pressing
the access (
) button.
After each press, the
uDirect 2 selects the
next connected source in a fixed sequence.
If a source is not connected, the uDirect 2 will
skip over it and proceed to the next source.
After the last connected source in the
sequence, streaming stops and your hearing
aids will resume the previously-active hearing
aid program, indicated by beeps.
Every connected audio source has a fixed place
in the sequence, as shown in the diagram.
Briefly press the access (
) button until you
reach your preferred audio source.
Previously-active
hearing program
3.5 mm plug
(audio jack)
FM
Europlug
Bluetooth
music 1
Bluetooth
music 2
• An FM receiver is inserted and receiving an
FM signal
• A Bluetooth music source is streaming music
or paused
• A Bluetooth phone is paired and within reach
A phone call always has priority. You will hear
the ringing indication even when listening to
other audio sources via cable, Bluetooth or
FM. If you reject or terminate the call, audio
streaming will resume.
It is not possible to change hearing aid
programs using the access ( ) button as
long as any audio source is connected to the
uDirect 2.
Most Bluetooth phones connect to the uDirect 2
as a phone and a music player at the same time.
If you want to listen to music, you must start the
music via your phone; it cannot be started from
the uDirect 2.
To Next Page
Loading...
Need help?
General
