Unitron uDirect 2 User Manual

3938
Streaming interruptions
To avoid streaming interruptions, make sure you
wear the uDirect 2 with the neckloop around
your neck and keep the Bluetooth device within
the operating range.
Situations where streaming may be interrupted:
If the uDirect 2 is too far away from the
hearing aids while streaming, e.g., if you
are not wearing the neckloop or if you have
unplugged the neckloop cable.
If the hearing aids are not worn correctly, e.g.,
if they are not in an upright position.
If the Bluetooth signal is out of range.
If the Bluetooth transmitter is affected by an
obstacle, e.g., when carrying a cellular phone
in the back pocket.
In these cases, your hearing aids will lose the
audio signal. If this situation continues for
more than approximately 5 seconds, they will
automatically switch to the previously-active
hearing aid program.
uDirect 2 will announce each active audio source
as you go through the sequence with spoken
notifications or beeps.
Pause streaming
To temporarily interrupt streaming, e.g., if
someone wants to speak to you in person,
briefly press the access (
) button on the
uDirect 2 as many times as needed until you
hear the beeps announcing the previously-active
acoustic hearing aid program.
To resume streaming, briefly press the access
(
) button until your preferred audio source is
found.
Pressing the home ( ) button will always
select the startup programs of your hearing aids,
regardless of the audio source sequence.
Stopping streaming
To stop audio streaming completely, stop the
Bluetooth audio players and unplug the audio
plug or the FM receiver.

Unitron uDirect 2 Specifications

General

Brand	Unitron
Model	uDirect 2
Category	Hearing Aid
Language	English