2120
Using uDirect as a remote control
for your hearing aid
Before the remote control functionality can be
used, your hearing healthcare professional must
enable the remote control.
There are two ways to use the uDirect
as a remote control:
• The neckloop is plugged in with
both ends, and the uDirect
must be worn around your neck.
The remote control function is
available as long as you are not
streaming audio.
• The neckloop is completely
un-plugged and uDirect is
operated at arm’s length. No
streaming is possible in this
conguration.
Make sure the uDirect is switched on.
Volume change
Press the ( ) volume button on the
uDirect to adjust the volume of your hearing
aids:
• Press ( ) to increase loudness
• Press ( ) to decrease loudness
Program change
Use the access ( ) button to change hearing
aid listening programs.
Changing hearing aid programs is only possible
if no streaming is in progress.
Press and hold the home (
) button (>two
seconds) to select your favorite hearing
program congured by your hearing healthcare
professional.
Push the home (
) button to return to the
startup hearing aid program and volume levels
of your hearing aids.
To Next Page
Loading...
Need help?
General
