Unitron uDirect 3 - Charging the Udirect 3; Turning the Udirect 3 on and off

98
Charging the uDirect 
Your uDirect  has a non-removable
rechargeable battery.
To charge it:
. Plug the mini-USB plug into the mini-USB
port on the uDirect .
. Plug the power supply into a power outlet.
During charging, the power indicator is solid
red, this typically takes  minutes.
When the battery is fully charged, the power
indicator is solid green.
It is safe to leave the uDirect  connected to
the charger overnight.
When charging your uDirect  for the rst time,
let it charge for at least three hours, even if the
battery indicator is not lit or turns green earlier.
A new battery’s full performance is achieved only
aer three complete charge and discharge cycles.
uTV
™
 can also be used as a charging station
for uDirect .
Turning the uDirect  on and o
Slide the power switch
(
) as shown to turn
the uDirect  on or o.
Switch the uDirect  o
when not in use or if in storage
or during transportation.
For operational use switch the uDirect  on.
O On