Unitron uDirect 3 Guide

5554
Deleting the pairing of Bluetooth
devices
If you encounter issues with one of the paired
devices, or if a device stops connecting to your
uDirect , you may consider deleting the pairing
of devices to the uDirect .
. Turn on your uDirect .
. Press and hold the (
) and
(
) buttons for ten seconds
until the blue rapid blinking
audio indicator stops.
. Also delete the uDirect
pairing entries on your
mobile phone before any
re-pairing.
. Repeat the pairing procedure.
Deleting the pairing of Bluetooth devices
removes the ability to connect to these devices.
You will need to perform the pairing process
again if you wish to reconnect.
Troubleshooting guide
Cause Possible remedy
During Bluetooth pairing my other device is prompting
for a code, what do I have to enter?
The pairing code is
required for the initial
coupling of uDirect 
with your Bluetooth
device (pairing)
The uDirect  pairing code
is “0000” (four zeros)
I hear intermittency during audio streaming via
uDirect
The Bluetooth
device is too far away,
or worn in a back pocket
(body shielding)
Do not to exceed the
maximum distance 5-10 m
(15-30 ) and keep Bluetooth
devices in front of you
uDirect  searches
for known devices
for two minutes aer
switching on
Aer two minutes, uDirect 
will stop searching and the
intermittency will stop
A phone connected
to other devices, such
as a PC, may not be
able to continuously
stream music
When using your Bluetooth
phone as music player,
disconnect it from other
devices, such as PCs

Unitron uDirect 3 Specifications

General

Brand	Unitron
Model	uDirect 3
Category	Hearing Aid
Language	English