EasyManua.ls Logo

Unitronics Vision V130-T2 - Page 9

Unitronics Vision V130-T2
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Vision™PLC+HMI
Unitronics
9
pnp (source) Input
Input wiring
HSC input wiring
Shaft-encoder
Analog Input
Analog input wiring, current (2/3-wire)
Analog input wiring, current (4-wire), Voltage
▪ Shields should be connected at the signal’s source.
▪ The 0V signal of the analog input must be connected to the controller’s 0V.

Related product manuals