Apollo x4 Hardware Manual Quick Start 13
Quick Start
Before you can use Apollo x4, you need to complete these steps:
1. Connect to your computer with a Thunderbolt 3 cable (not included).
2. Connect to AC power.
3. Download and install the latest UAD software.
4. Register your Apollo hardware.
5. Authorize your UAD plug-ins.
Additionally, you'll want to learn these essential Apollo x4 operations:
• Connect to Input Sources and Monitor System – How to connect your audio gear.
• Setting Hardware I/O Levels – Learn how to adjust Mic/Line/Instrument input gain
levels and monitor/headphone output volume levels.
This chapter will guide you through these steps. For assistance, see the Technical
Support page.
Installation Notes
• Locate the interface on a flat surface so its feet will maintain airflow beneath the
unit.
• The location should be sturdy enough to securely hold its weight and withstand
the pressure of operating the top panel controls.
• Allow space at the front and rear of the unit for cable connections.
• Do not block the cooling vents on the bottom or sides of the unit.
• As with any sound system, the following steps are recommended to avoid audio
spikes in your speakers and headphones:
1. Power on the speakers last, after all other devices (including Apollo x4) are
powered on.
2. Power off the speakers first, before all other devices (including Apollo x4) are
powered off.
3. Remove headphones from ears before powering Apollo x4 on or off.
To Next Page
Loading...
Need help?
General
