18
DO NOT TAKE or SEND PRODUCT BACK to where this product was purchased. Please contact Universal Fitness/FFA Corp.
for missing or defective parts at one of the following: Phone 1-800-521-6233 or Fax 1-662-495-5038 or E-mail at
customerservice@universal-fitness.com. Mailing address: Universal Fitness/FFA Corp. - 100 Tubb Ave. West
Point MS 39773. Web sight www.universal-fitness.com
FIGURE 7
Step 35.
Step 36.
Step 37.
Step 38.
Step 39.
Step 40.
Step 41.
Step 42.
Step 43.
Attach SQUARE BUMPER (53) to the end of SEAT SUPPORT FRAME (15) with M10 x 25mm SCREW (83).
Attach SEAT SUPPORT FRAME (15) to RIGHT VERTICAL FRAME (5) with 3/8” x 4” HEX BOLTS (73), 3/8” WASH-
ERS (90), CONNECT PLATE (36) and 3/8” LOCKNUTS (86).
Push 20mm x 40 RECTANGLE PLUGS (47) into ends of SUPPORT BEAMS (16) and attach SUPPORT BEAMS to
SEAT SUPPORT FRAME (15) and RIGHT BASE BEAM (1) with 3/8” x 4-1/8” HEX BOLTS (72), 3/8” WASHERS (90)
and 3/8” LOCKNUTS (86).
Push 2” ROUND BUSHINGS (50) into each side of RIGHT BASE BEAM (1).
Push two 50mm SQUARE END PLUGS (45) and four 20mm x 40 RECTANGLE PLUGS (47) into CONNECT FRAME
(18).
Attach CONNECT FRAME (18) to RIGHT BASE BEAM (1) with 3/8” x 4-3/8” HEX BOLT (71), 3/8” WASHERS (90) and
3/8” LOCKNUT (86).
Slide 50mm x 45mm BUSHINGS (48) over each end of guide tube at top of CONNECT FRAME (18).
Push 45mm SQUARE END PLUGS (46) into ends of FOOT PLATE EXTENSION (19) and insert FOOT PLATE EXTEN-
SION through 50mm x 45mm BUSHINGS (48) and lock at desired position with “U” LOCK (37).
Slide FOOT PLATES (20) onto FOOT PLATE EXTENSION (19) and fasten with 3/8” x 3/4” HEX BOLTS (82) and 3/8”
WASHERS (90).
NOTE: DO NOT overtighten. FOOT PLATES must pivot freely.
To Next Page
Loading...
