4
DO NOT TAKE or SEND PRODUCT BACK to where this product was purchased. Please contact Universal Fitness/FFA Corp.
for missing or defective parts at one of the following: Phone 1-800-521-6233 or Fax 1-662-495-5038 or E-mail at
customerservice@universal-fitness.com. Mailing address: Universal Fitness/FFA Corp. - 100 Tubb Ave. West
Point MS 39773. Web sight www.universal-fitness.com
Comments or Questions?
Dear customer,
Congratulations on your purchase of the
Universal Eight Station PLUS Corner Gym.
We’re sure that you will be completely satisfied with the product and we invite your comments so that we can hear
about your success.
Please write or call at the address or phone numbers listed below, with any comments or questions you may have.
Service and Parts - Toll free number: 1-800-521-6233 Monday through Friday-8:00 am to 4:30 PM Central Time
Fax: 1-662-495-5038
E-mail: customerservice@universal-fitness.com
Website: www.universal-fitness.com
Universal Fitness™
A Division of FFA Corp.
Customer Service Department
100 Tubb Ave.
West Point, MS 39773
Ordering Missing or Defective Parts
When ordering parts, always provide the following information:
1. NAME, MAILING ADDRESS AND TELEPHONE NUMBER
2. DATE OF PURCHASE
3. WHERE PRODUCT IS PURCHSED (NAME OF RETAIL STORE,CITY)
4. MODEL NUMBER (75015)
5. PART ORDER NUMBER AND DESCRIPTION
All details depicted in this Owner’s Manual, and of the product itself, are subject to change without notice.
Before you begin
1. FIND YOUR TOOLS: You need two adjustable crescent wrenchs and one rubber mallet. These tools are
NOT included in the carton.
2. LOCATE YOUR WORK OUT AREA: For your safety and convenience, you must assemble the
unit exactly where it is to be used, so that you will not have to move it once the assembly is complete.
Allow ample space for the unit and space for the spotter to stand. The area must have adequate
lighting and ventilation. If the area is within living quarters, protect the carpet or floor with a large mat
prior to assembly.
3. GET A HELPER: It is recommended that two adults assemble the product. All persons involved in the
assembly should be in good health, and exercise great caution while manipulatingheavy metal objects.
Keep children away during assembly.
4. IDENIFY YOUR HARDWARE: To identify a piece of hardware by physical size, use the scales
provided on page 5, on back of hardware or metric ruler. To remove hardware from hardware card cut
boxes out of the back.
5. TIGHTEN ALL BOLTS BY HAND FIRST: Do not tighten any bolts until the entire unit is assembled.
Initially, all bolts should only be hand-tightened. Once all parts are in place, begin tightening the bolts at the
top of the unit first, and work your way down to the floor.
6. INSTALLING FOAM ROLLS and GRIPS: Liquid soap applied to inside of FOAM ROLLS and GRIPS
then outside of TUBES will help FOAM ROLLS and GRIPS slide on easier. When soap dries, the FOAM
ROLLS and GRIPS will stay in place.
To Next Page
Loading...
