28
DO NOT TAKE or SEND PRODUCT BACK to where this product was purchased. Please contact Universal Fitness/FFA Corp.
for missing or defective parts at one of the following: Phone 1-800-521-6233 or Fax 1-662-495-5038 or E-mail at
customerservice@universal-fitness.com. Mailing address: Universal Fitness/FFA Corp. - 100 Tubb Ave. West
Point MS 39773. Web sight www.universal-fitness.com
FIGURE 14
Step 78.
Step 79.
Step 80.
Step 81.
Step 82.
Step 83.
Step 84.
Step 85.
Step 86.
Insert cable adjuster end of WEIGHT CABLE (66) through slot in LEFT VERTICAL FRAME (7) down in front of PRESS
BAR (14).
Thread cable adjuster of WEIGHT CABLE (66) into SELECTION ROD (38) about 3 or 4 turns and tighten locking nut
against SELETCTION ROD.
NOTE: Over time the cables will need to be adjusted to remove excess slack. This can be done by threading the cable
adjuster into the SELECTION ROD until the slack has been removed and then tighten locking nut against SELECTION
ROD.
Push 23mm BUSHINGS (93) into each side of LEFT VERTICAL FRAME (7) on each side of slot.
NOTE: Attachment of the five PULLEYS (42) used with the WEIGHT CABLE (66) will require the WEIGHT CABLE be
placed in groove of PULLEY as it is attached.
Attach PULLEY in slot of LEFT VERTICAL FRAME (7) with 3/8” x 3-5/8” HEX BOLT (75), 3/8” WASHER (90) and 3/8”
LOCKNUT (86).
Attach PULLEY (42) between PULLEY BRACKET PLATES (3) with 3/8” x 2” HEX BOLT (80), 3/8” WASHER (90) and
3/8” LOCKNUT (86).
Attach PULLEY (42) to bracket on bottom of PRESS BAR (14) with 3/8” x 2” HEX BOLT (80), 3/8” WASHER (90) and
3/8” LOCKNUT (86).
Attach PULLEY (42) to bracket on bottom of TOP CENTER FRAME (29) with 3/8” x 2” HEX BOLT (80), 3/8” WASHER
(90) and 3/8” LOCKNUT (86).
Attach a PULLEY (42) to one end of second DOUBLE PULLEY BRACKET (33) with 3/8” x 2” HEX BOLT (80), 3/8”
WASHER (90) and 3/8” LOCKNUT (86).
Attach DOUBLE STRAP (58) to end of WEIGHT CABLE (66) with HOOK (60).
To Next Page
Loading...
