30
DO NOT TAKE or SEND PRODUCT BACK to where this product was purchased. Please contact Universal Fitness/FFA Corp.
for missing or defective parts at one of the following: Phone 1-800-521-6233 or Fax 1-662-495-5038 or E-mail at
customerservice@universal-fitness.com. Mailing address: Universal Fitness/FFA Corp. - 100 Tubb Ave. West
Point MS 39773. Web sight www.universal-fitness.com
FIGURE 15
Step 87.
Step 88.
Step 89.
Step 90.
Step 91.
Step 92.
Step 93.
Step 94.
Step 95.
Step 96.
Insert the eye end of the LOWER CABLE (63) through slot at bottom of LEFT VERTICAL FRAME (7) and under
PULLEY (42) attached between the PULLEY BRACKET PLATES (3).
Attach eye end of LOWER CABLE (63) to TAB on RIGHT BASE BEAM (1) with HOOKS (60) and CHAIN (61).
NOTE: When removing slack from cables, first adjust CHAIN to remove most of the slack. Then adjust the cable
adjuster for small amounts.
NOTE: Attachment of the eight PULLEYS (42) used with the LOWER CABLE (63) will require the LOWER CABLE be
placed in groove of PULLEY as it is attached.
Attach PULLEY to upper DOUBLE PULLEY BRACLET (33) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS (90) and
3/8” LOCKNUT (86).
Attach PULLEY (42) to end bracket of RIGHT BASE BEAM (1) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS (90) and
3/8” LOCKNUT (86).
Attach PULLEY (42) to other DOUBLE PULLEY BRACKET (33) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS (90)
and 3/8” LOCKNUT (86).
Attach PULLEY (42) to end bracket of LEFT BASE BEAM (2) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS (90) and
3/8” LOCKNUT (86).
Attach PULLEY (42) to bracket next to LEFT VERTICAL FRAME (7) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS
(90) and 3/8” LOCKNUT (86).
Attach PULLEY (42) to bracket on LEG EXTENSION (12) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS (90) and
3/8” LOCKNUT (86).
Attach PULLEYS (42) to last two brackets on LEFT BASE BEAM (2) with 3/8” x 2” HEX BOLT (80), 3/8” WASHERS
(90) and 3/8” LOCKNUT (86).
Attach CURL BAR (31) or ANKLE STRAP (57) to end of LOWER CABLE (63) with HOOK (60) or HOOKS and CHAIN
(61).
To Next Page
Loading...
