Need help?Do you have a question about the Universal L60 and is the answer not in the manual?
General| Brand | Universal |
|---|---|
| Model | L60 |
| Category | Label Maker |
| Language | English |
Provides a general overview of the L60 label applicator's features and operation.
Details the main and motor switches on the applicator's front panel.
Explains how product detection works and how to configure it for leading/trailing edge.
Offers starting points for air cylinder and vacuum pump pressure settings.
Lists the items included in the shipping carton and instructions for unpacking.
Outlines the warranty terms and conditions for the label applicator.
Describes the 30-day performance guarantee and correction policy.
Lists the technical specifications including electrical power, air requirements, and dimensions.
Provides step-by-step instructions for mounting the Unwind Assembly to the L60 body.
Explains the working principle of the unwind assembly and brake arm tension.
Details the procedure for removing the waste web from the rewind spool.
Describes different methods for mounting the L60 label applicator, including bottom and top mounts.
Explains the dwell timer function and how to set it for tamp applicators.
Describes the optional lower sensor and provides adjustment instructions.
Explains the optional smart head for handling product variations and its operation.
Details how labels are transferred from the peeler plate to the vacuum head and air assist.
Describes the air assist tube's function and how to adjust its air pressure for label transfer.
Provides detailed instructions and diagrams for threading the label web through the machine.
Guides the user on starting and operating the L60 label applicator, including web tracking.
Explains the function of the star wheel in label dispensing and provides adjustment procedures.
Details the setup procedure for the optional Data Logic sensor.
Explains the setup procedure for the optional Lion sensor.
Instructions for cleaning and sharpening the starwheel label sensor.
Covers cleaning the drive roll and adjusting rewind assembly tension.
Focuses on troubleshooting label registration issues and their causes.
Explains the principles of vacuum head operation and factors affecting performance.
Provides contact information for technical assistance, including email and web address.
Configures delay settings for start and stop signals based on DIP switch positions.
Selects the machine model (L15 or L60) using DIP switches.
Sets clutch/brake delay timing based on DIP switch and model selection.
Configures the product switch to detect signals from leading or trailing edges.
Configures the label sense switch for signal detection from leading or trailing edges.
Details jumper settings for product switch type, polarity, and stop signal selection.
Electrical diagram for L-60 Tamp-On applicator, showing wiring details.
Electrical diagram variant for L-60 Tamp-On applicator, showing wiring details.
Electrical diagram for L-60 Tamp & Blow applicator, detailing wiring.
Electrical diagram variant for L-60 Tamp & Blow applicator, detailing wiring.
To Next Page