6
INSTALLATION
IT IS STRONGLY RECOMMENDED TO HAVE A CERTIFIED ELECTRICIAN
ON SITE TO ENSURE THE SAFE INSTALLATION OF YOUR THERMOSTAT.
The manufacturer assumes no responsibility for improper wiring, or any resulting damages.
Improper installation by a non-professional automatically voids the warranty.
Before installation begins:
Verify that the heating appliance being connected to is within the specified load range
Ensure that the thermostat being replaced is also rated for 120 or 240 volts.
Ensure that the heating system is protected by appropriate circuit breakers or fuses
Connect to COPPER conductors only.
TO AVOID FIRE, SHOCK, OR DEATH; SHUT OFF POWER SUPPLY
AT THE CIRCUIT BREAKER OR FUSE AND TEST THAT THE POWER IS
OFF BEFORE WIRING.
*
Final Size: 5” x 3” / 12.5cm x 7.5cm
To Next Page
Loading...
