Upright SL26SL Service Manual

1-1 SL26/30SL Service & Parts
Section 1
INTRODUCTION
1.1 INTRODUCTION
PURPOSE
The purpose of this service and parts manual is to provide instructions and illustrations for the
operation and maintenance of this work platform manufactured by UpRight.
SCOPE
The manual includes procedures for proper operation, maintenance, adjustment, and repair of
this product as well as recommended maintenance schedules and troubleshooting.
1.2 GENERAL DESCRIPTION
The work platform consists of the platform, controller, elevating assembly, power module, control
module, and chassis.
Figure 1-1: SL26/30SL Work Platform
PLATFORM
The platform has a reinforced steel
floor, 1.1m (43.5 inch) high guardrails
with midrail, 152 mm (6 inch ) toe-
boards, and an entry gate at the rear of
the platform. The guardrails can be
folded down for access through doors or
for shipment.
PLATFORM CONTROLLER
The platform controller contains the
controls to operate the machine. It is
located at the front of the platform cage.
A complete explanation of control func-
tions can be found in Section 2.
ELEVATING ASSEMBLY
The platform is raised and lowered by
the elevating assembly. The hydraulic
pump, driven by the engine, powers the cylinder. Solenoid operated valves control raising and
lowering.
WARNING
!
!
DO NOT use the work platform without guardrails properly assembled and in
place.
1.Platform
2.Platform Controller Assembly
3.Elevating Assembly
4.Power Module
5.Control Module
6.Chassis
1
3
4
2
5
6

Upright SL26SL Specifications

General

Brand	Upright
Model	SL26SL
Category	Scissor Lifts
Language	English