DS1067-062C 30 LBT20063
9) After 5 seconds, the status LED will switch off and the squares will become empty
indicating that the zones have been disarmed. The following will appear on the display:
10) Press if you do not want to wait for 5 seconds.
11) The display will go back to standard view automatically after one minute. Press
to go to standard view immediately.
IMPORTANT! The user will disarm only the assigned zones and not necessarily all the zones even with this
procedure.
2.8.5 Disarming from keypad under hold-up
On the 1067/024 control panel, starting from control panel SW version 1.00 and on 1067/032A and 1067/052A, control
panels, starting from control panel SW version 1.01, if the hold-up function has been enabled and you are threatened and
forced by a criminal with the risk of life then, you can disarm the burglar system while arming the hold-up alarm
simultaneously which will make the dialer sending the programmed alarm messages without activating the siren sound.
To disarm the system when your are under hold-up, just increase your user code of one digit. For example if your user
code is 000021 you need only to enter 000022; if user code is 29 enter 30, if it is 39 enter 40, etc.
IMPORTANT! Enabling the hold-up function will cancel EN50131 compliance.
2.9 DISARMING WITH ELECTRONIC OR PROXIMITY KEY
2.9.1 Total disarming from electronic key reader
2.9.1.1 System in use mode = Mode 3 (EN50131 grade 3 compliant)
Proceed as follows to disarm all zones assigned to the reader and to the key using the electronic key:
1. Insert the electronic key in the reader. The red LED will blink to indicate that the key is being read and the green LED
will light up after a few instants to indicate that the key was recognised. All the green LEDs will blink rapidly if the key is
not recognised.
2. The green LEDs corresponding to the armed zones, if any, will appear if the key is recognised. The red LED will keep
blinking.
3. Extract the key.
4. Insert the electronic key again after a few instants.
5. Extract the electronic key when the red LED starts blinking.
6. The green LEDs will go out. A LED will stay on to indicate that the key is not assigned to the zone. The possibility of
disarming each zone depends on the programming of the reader and on the key used.
IMPORTANT! The key will disarm only the assigned zones and not necessarily all the zones even with this
procedure.
2.9.1.2 System in use mode = Mode 2 or Mode 0
Proceed as follows to disarm all zones assigned to the reader and to the key using the electronic key:
1. Insert the electronic key in the reader. The red LED will blink to indicate that the key is being read. All the green LEDs
will blink rapidly if the key is not recognised.
2. Extract the electronic key when the red LED starts blinking.
3. The green LEDs indicate the status of the zones assigned to the reader. LED off = zone disarmed, LED on = key not
assigned to the zone. The possibility of disarming each zone depends on the programming of the reader and on the
key used.
IMPORTANT! The key will disarm only the assigned zones and not necessarily all the zones even with this
procedure.
EXECUTE
To Next Page
Loading...
Need help?
General
